მაღალტემპერატურული სილიკონი

მაღალი ხარისხის დასაწებებელი და დასალუქი ნაერთი

მრეწველობაში და საავტომობილო სექტორში გამოსაყენებლად.

მდგრადია ქიმიკატების მიმართ

შესანიშნავად უძლებს ზეთს, ანტიფრიზს.

არ არის კოროზიული, ამიტომ არ აქვს უარყოფითი გავლენა ელექტრონულ კომპონენტებზე და ლამბდა ზონდებზე.

დალუქულია შეკუმშული ჰაერის ქილაში

მარტივია გამოსაყენებლად დამატებითი დამხმარე საშუალებების გარეშე.

ColourBlackContents200 mlChemical basisNeutral crosslinked silicones, oxime-basedSmell/fragranceCharacteristicMin./max. temperature resistance-60 to 260 °CMax. short-term temperature resistance300 °CRange of applicationsWater pumps

Oil pumps

Front cover

Camshaft bearing cover

Thermostat housing

Oil pans

Transmission cover

Sunroof

DoorsDensity1.25 g/cm³Min. skin-formation time5 minConditions for skin-formation timeat 23°C and 50% relative humidityFull curing speed3 mm/dFully hardening/curing conditions23°C and 50% relative humidityShore A hardness30Min. tensile strength2.2 N/mm²Conditions for tensile strengthin accordance with ASTM D-412Max. breaking elongation/conditions550 % / in accordance with DIN 53504Heat conductance λ0.2 J/(msK)Heat conductance λ conditionsin accordance with ASTM D-2214/70Coefficient of thermal expansion0.0002 1/KCoefficient of thermal expansion conditionsin accordance with ASTM EB-31Dielectric strength16 kV/mmDielectric strength conditionsin accordance with ASTM D-149Relative permittivity2.8Conditions for relative permittivity1 MHz, ASTM D-150Loss factor0.002Loss factor conditions1 MHz, ASTM D-150Specific volume resistivity1000000000000000 Ohm/cmConditions for specific volume resistivityin accordance with ASTM D-257High-quality adhesive and sealing compound for use in industry and the automotive sector.

Excellent resistance to chemicals

Can also be used in critical areas in which the seal comes into contact with various liquidsOutstanding resistance to engine oil and transmission oil, refrigerant and anti-freeze agentNon-acidic hardening system

Non-corrosive, therefore has no negative impact on electronic components and on lambda probesSealant in compressed-air can

Easy to dispense without additional aidsThe fine beads allow the product to be applied uniformlyNotice

When sealing e.g. oil pans and gearboxes it is vital that no sealant gets into the interior. For this reason we recommend to apply the sealant on a joining part surface. Join both parts and then carefully press by hand and lightly slide against each other. Afterwards separate the parts again and then remove the sealant that has gone inside. Join the components again within a max. of 5 minutes and tighten firmly. Before commissioning, observe the hardening time (depending on the sealant thickness).